1 / 2
Makita bit holder with adaption for Magnetto magnet — zdjęcie 1
1 / 2

Makita bit holder with adaption for Magnetto magnet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of the Makita bit holder with adaptions to add a Magnetto magnet

Ocena
0 / 5
Polubienia
0
Pobrania
10
Wydruki
0
Wyświetlenia
102
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

This is a remix of the Makita bit holder with adaptions to:

- add a Magnetto magnet
- reinforce the holders
- lengthen the holders for easier access once the magnet is added.

### Printing suggestions:

Print it standing on the bottom end so that the layers are perpendicular to  the opening for the bits. Printing it on the flat surface with the screw holes in it, results in parallel layers to he holders, which can more easily break when in use.

### Partial description the [original](https://www.thingiverse.com/thing:2786073):

This bit holder is designed to be as low profile as possible.  It holds 2 bits.  The bits are held in by friction, but there are also little detent bumps within the holder.

There is a tongue on the holder that goes into the little 1" long slot (similar to how the standard belt clip attaches).  That makes it very secure, but it also means the holder will only fit on the right hand side of the drill/driver.  If you want it on the left, print a mirrored version (or I suppose you could drill another hole in the right spot)

Use an M4 screw to attach it.
 

Tagi