Decora Adapter for Phillips Hue Dimmer (Original / On-Off buttons)

This adapter allows your Phillips Hue Dimmer switch (original model with on/off buttons) to fit on top of a Decora light switch. For the 2nd gen dimmer, see here.

This provides an ideal solution from a UX standpoint as the original light switch is not visible to the user, so they won't hit the hardwire switches, but they are still easily accessible if needed by simply removing the Dimmer. 

Print it upright, no supports (you may need to tune your bridging, but it still works fine if there's slight sag). 

Use it with 15mm x 2mm neodynium magnets. The original dimmer has no magnets in the back, just metal, so their orientation does not matter. 

For mounting to the light switch I use two, small 3M command strips (poster size). I cut off the little bit at the square end with no adhesive, cut them each in half vertically, and put one in each corner.