K1 Manta M5P fan mount and skirt
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I started with Bootycall Jones' Manta M5P mount for the vanilla K1 and added some features
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 512
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to run mainline Klipper and use a Cartographer probe. This meant replacing the main board. I chose a BTT Manta M5P. Bootycall Jones had generously provided a mount for the new board and a model to mount the stock fan above the mainboard.
The bottom of the printer no longer fit when the new fan mount was installed. There wasn't a lot of room in the bottom of the printer and the belts that connect the three z-axis screws have no shrouds.
I created the skirt to provide more room in the “electronics dungeon” in the printer and provide tie downs for the wiring. The skirt's bridge is perforated so the wiring from the PSU to the main board can pass through far away from the belt routing.
All of my parts have many holes that can be used with zip ties to secure the wiring.
The skirt is held in place with counterbored screws in the locations where the metal plate used to go. You will need to drill new holes in the metal plate that align with the heat insert holes in the skirt. These holes are about 20mm away from the existing holes. You may also want to cut a new hole in the metal plate aligned with the new fan location above the MCU. Or just cut a new bottom plate out of clear acrylic or something.
Use your best judgment with print orientation. This is a work in progress. When I am 100% satisfied I will update the models and provide more guidance for print orientation. Print two of each type of butterfly key.
All parts will print on the K1 itself except for the bridge. It is just barely too big to fit in the K1. I printed mine on my Bambu P1S.
