1 / 6
3d printable Mechanum Wheel
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mechanum wheels which can be fully 3d printed, only requires four 15mm M3 screw and nuts.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 495
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Public Domain
SzczegółyPliki (9)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (15)Powiązane
This is a 3d printable mechanum wheel compatible with MG995/MG996R servos.
Dimensions:
- Diameter : 61.7 mm
- Thickness: 19 mm
Parts:
- Wheel A and B:
- The wheel body is separated into two halves, lower and the upper
- Common:
- rollers
- shafts which attach the rollers to the wheel body.
- Extras:
- 4 M3x16 screws ( and nuts).
Printing:
- Material: Standard PLA+
- Supports (required for wheel body):
- Type: Normal
- Pattern: Rectilinear
- XY separation: 0.5
- Top Z distance: 0.2
- 10 rollers and 10 shafts needed per wheel.
- Print the shafts and rollers separately from other parts.
Assembly:
- The wheel_lower part fits with the wheel_upper part with 3 M3x16 screws.
- Align the three screw-holes precisely as sometimes the holes might align but the alignment of the lower and upper bodies might be off by 120 or 240 degrees.
- The wheel_cap ( this part was not tested by me as I only had M3x20 screws available) can be used in place of nuts to hold the body parts together.
- One M3x16 screw goes through the center of the wheel to the servo.