1 / 2
DJI O4 Air Unit Pro Camera Lens Cap
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple lens cap for the DJI O4 Air Unit Pro Camera.
- Ocena
- 4 / 5
- Polubienia
- 26
- Pobrania
- 411
- Wydruki
- 1
- Wyświetlenia
- 958
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (31)Powiązane
Lens cap design principles:
- easy to install and remove, but stays in place
- make use of the camera's accessory notches to keep the cap in place.
- minimal footprint, with a width of 20mm (like the camera itself), to fit most frame camera cage designs.
- leaves a gap between the actual lens and the cap, to avoid smears.
Please note that this lens cap is meant to be printed in TPU as the small tabs (that fit in the camera hood notches) will not allow the cap to be installed if printed in a stiff material like PLA or PETG.
If you wish to print for resale, or if you need custom changes, contact me.
