ECAS04 Bulk head Filament Guide - Drybox
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple ECAS04 Bulkhead Guide for a filament dry box or other bulkhead where you would like to pass filament
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 233
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple and easy to print (no supports needed) ECAS04 bulkhead fitting/filament guide.
I am using the Gunpla filament dry box and i didn't have any of the fitting that were needed for the filament pass through, however i had a lot of ECAS04 fitting so i designed this simple fitting. it is M10 (drill a hole around 11mm) and the thread depth is 8mm so has a wide range of uses. the ECAS is on the one side with a nice smooth transition of the other side for the filament to avoid any snagging.
I have produced a long and short version of the ‘nut’ the thread depth is the same, but for tight areas the short nut would be better than the long version.
Note: the threads are a little tight, i didn't want issues with it coming loose!, Prior to fitment ensure you screw the two halves together, screw in about quarter of a turn and then back it off, and repeat until the two pieces meet, it doesn't take much effort, once done it screws together perfectly fine
Enjoy and please share your prints and applications