1 / 2
A-arm suspension for The Marmot rc car
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Alternative rear suspension for The Marmot, an RC car
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 118
- Wydruki
- 0
- Wyświetlenia
- 735
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (21)Powiązane
A-arm type rear suspension for The Marmot - https://www.printables.com/model/1149568-the-marmot-110-scale-off-road-buggy
Instead of the swing axle type suspension included in The Marmot, this type uses the same a-arms as the front of the car.
You'll need four 3x35 mm dowels (or m3 screws), four countersunk m3x20 screws and m3 heat inserts for the arms. (No need for OD 6 mm tubes and mr106 bearing as listed with The Marmot)