1 / 2
EBB42 / xxx42 CAN Bus Board Mount for Galileo 2 Extruder — zdjęcie 1
1 / 2

EBB42 / xxx42 CAN Bus Board Mount for Galileo 2 Extruder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Toolhead board mount for the Galileo 2 Extruder compatible with EBB42-style square toolhead boards

Ocena
0 / 5
Polubienia
16
Pobrania
72
Wydruki
0
Wyświetlenia
745
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

A mount to use an EBB42-style square toolhead board with the Galileo 2 extruder on the Voron Stealthburner. Compatible with original G2E parts and the original CB-G2 cable gland mount. I've included a modified cable gland mount with slightly looser thread tolerances and a zip tie cutout (green in CAD screenshot). 

xxx42 boards are slightly too large for the rear door on the CB-G2, but using the attached STEP file to create a compatible door shouldn't be too difficult. The CB-G2 cable cover should work but I haven't tested it. JosAr's cable cover from the Galileo 2 repo is what's in use in the photo.

BOM for the pictured setup is mostly the same as the CB-G2. Uses 4 heatsets instead of 2 hex nuts to attach the board to its mount. Hardware for the rear door not listed.

  • M3 Heatset Inserts x4
  • M3x6 SHCS x4
  • M3x6 SHCS or FHCS x1 (for cable cover, should be in your Galileo 2 kit)
  • M3x35 SHCS x1
  • M3x45 SHCS or M3x50 SHCS x1 (should be in your Galileo 2 kit)
  • PG7 Cable Gland
  • BTT EBB42 or similar toolhead board

A-drive umbilical strain relief mount that I'm using.

Tagi