V-Core 4 Corner Anti-Warp Magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An additional way to keep corners from warping out at high temps on your VC4 (requires the original mod as well)
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 253
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This adds additional magnet on each side to the original method of preventing the corners from warping. You will need to install the original mod that this is a remix from: https://www.printables.com/model/986607-fix-corner-warp
Requires 4x 10mm OD x 4mm deep neodymium magnet (same type RatRig uses for the front/top panel magnetic mount). You may also need a longer M6 bolt to bolt the Side Magnet piece to the sides of your machine depending on your panel thickness. Note - this piece only uses one bolt to bolt down, and then just tightly rests around the second bolt to make install easier.
Depending on where exactly you drilled your hole in the front panel for the original mod and the tolerances when your front panel was cut, you will likely need to modify the Front Door Piece to have the appropriate clearances and fit nicely over your front panel while still lining up with the Side Magnet piece. Step file is included to make this easier.