IKEA Skådis Holder for Phomemo P12 Label Printer | T Nut System

IKEA Skådis Holder for Phomemo P12 Label Printer | T Nut System

This custom-designed holder is specifically made to securely store the Phomemo P12 label printer on an IKEA Skådis pegboard. The Phomemo P12 is a great choice for anyone working with Gridfinity or other modular storage setups, thanks to its ability to print 12mm wide labels, which are commonly used in such systems.

The holder is compatible with the T Nut system for Skadis developed by @6d6178 and uses 3 T Nuts with M2.5 screws (12mm length). While two screws are sufficient, the third screw provides extra stability for a more secure hold.

This model prints cleanly in its provided orientation with no supports needed and works with any material. Example images show it printed in PLA with a 0.2mm layer height.

For added convenience, I’ve also uploaded a model for holding refill tapes for the Phomemo P12 label printer, which can be found here.

You can purchase the Phomemo P12 label printer on Amazon to pair it with this holder.

✅ Features

• Compatible with T Nut System: Securely attaches to IKEA Skådis pegboards.
• Custom Fit for Phomemo P12: Designed specifically for the label printer itself.
• Support-Free Design: Prints cleanly in the provided orientation.

📃 Print Settings

• Material: PLA tested, compatible with PETG or other filaments.
• Layer Height: 0.2 mm (other heights also work).
• Supports: None required.
• Hardware Needed: 3 T Nuts and 3x 12mm M2.5 screws.

🛠 How to Use

1. Print the holder in the provided orientation without supports.
2. Insert 2-3 screws through the holes and attach one T Nut to each screw.
3. Use the alignment guides on the back of the holder to position it accurately on the Skådis pegboard.
4. Tighten the screws to secure the holder (avoid over-tightening).
5. Place your Phomemo P12 label printer in the holder for convenient access.

For more information about how T Nuts work and how to install them, refer to this link.

📸 Share Your Print

Show me how you’re using this holder! Upload a Make with photos and share how you’ve integrated it into your workspace.

💡 Feedback Welcome!

Have suggestions for improvements or need adjustments for a different printer size? Leave a comment or message me for custom modifications or ideas!

❤ Enjoyed This Model?

If you found this model helpful, consider giving it a like! Your support means a lot and helps me create more designs like this.