IKEA Skådis Label Refill Holder | Phomemo & Dymo Compatible | T Nut System

IKEA Skådis Label Refill Holder | Phomemo & Dymo Compatible | T Nut System

This custom-designed holder is perfect for organizing label refills for Phomemo P12, P12 Pro, LT12, and Dymo LetraTag printers. The design securely attaches to IKEA Skådis pegboards using the T Nut system developed by @6d6178, ensuring a stable and reliable mounting solution.

The holder can accommodate up to 5 label refill packs, which is the standard quantity available in bundles on Amazon. Each refill can be stored either in its original plastic wrap to prevent degradation or without the packaging, offering flexibility based on your needs.

A convenient cutout at the bottom allows easy removal of the last refill pack, ensuring quick access when you’re running low.

This model uses 2 T Nuts with 14mm M2.5 screws for mounting. No supports are needed for printing, and the example was printed in PLA with a 0.2mm layer height, but any material or layer height will work just as well.

Looking for the Phomemo P12 label printer holder? Check it out here. You can also find label refill packs for Phomemo and Dymo on Amazon.

✅ Features

• Compatible with T Nut System: Securely attaches to IKEA Skådis pegboards.
• Versatile Usage: Holds up to 5 label refills for Phomemo and Dymo printers.
• Convenient Design: Cutout at the bottom for easy removal of the last refill pack.
• Support-Free Design: Prints cleanly in the provided orientation.
• Protective Storage: Fits refills with or without their original plastic packaging.

📃 Print Settings

• Material: PLA tested, compatible with PETG or other filaments.
• Layer Height: 0.2 mm (other heights also work).
• Supports: None required.
• Hardware Needed: 2 T Nuts and 2x 14mm M2.5 screws.

🛠 How to Use

1. Print the holder in the provided orientation without supports.
2. Insert 2 screws through the holes and attach one T Nut to each screw.
3. Use the alignment guides on the back of the holder to position it accurately on the Skådis pegboard.
4. Tighten the screws to secure the holder (avoid over-tightening).
5. Insert up to 5 label refill packs into the holder, either in their original plastic packaging or unwrapped.

For detailed documentation on T Nuts and how to install them, refer to this link.

📸 Share Your Print

Have you printed and used this holder? Upload a Make with photos, and share how you’re organizing your labels!

💡 Feedback Welcome!

Need adjustments for a different number of refills or have improvement suggestions? Drop a comment or message me for custom modifications or ideas!

❤ Enjoyed This Model?

If you found this model helpful, consider giving it a like! Your support means a lot and helps me create more designs like this.