IKEA TISKEN Parallel Toilet Roll Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This (alternative mount) holds the toilet roll in an IKEA TISKEN parallel to the wall, rather than perpendicular.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 46
- Wydruki
- 1
- Wyświetlenia
- 226
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
This mount can be used in the IKEA TISKEN series of suction cups. Instead of the standard available toilet roll holder which comes with a perpendicular “stick”, this mount will hold the toilet roll parallel to the wall in a more standard fashion.
Required Materials
Two variants are provided. the “regular” variant provides countersink pockets for DIN912 bolts. The NO_COUNTERSINK version omits these and allows any type of M3 bolt to be used. (add ~3mm to the minimum bolt length)
In addition to the prints, the following parts are required:
2x M3 Bolt, Length between 8mm and 20mm ("regular version")
OR 2x M3 Bolt, Length between 12mm and 22mm ("NO COUNTERSINK version")
3x M3 Nut
Assembly Instructions
- Insert the M3 nuts into the nut traps, pusing them all the way down.
- Holding just the MOUNT, screw in the M3 bolt and tighten.
- Screw the MOUNT piece onto the HOLDER, leaving a little bit of space to allow for rotation.
- Screw the CAP onto the HOLDER
- Slide the MOUNT into the TISKEN suction cup.