IKEA TISKEN Parallel Toilet Roll Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This (alternative mount) holds the toilet roll in an IKEA TISKEN parallel to the wall, rather than perpendicular.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 46
- Makes
- 1
- Views
- 226
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial
This mount can be used in the IKEA TISKEN series of suction cups. Instead of the standard available toilet roll holder which comes with a perpendicular “stick”, this mount will hold the toilet roll parallel to the wall in a more standard fashion.
Required Materials
Two variants are provided. the “regular” variant provides countersink pockets for DIN912 bolts. The NO_COUNTERSINK version omits these and allows any type of M3 bolt to be used. (add ~3mm to the minimum bolt length)
In addition to the prints, the following parts are required:
2x M3 Bolt, Length between 8mm and 20mm ("regular version")
OR 2x M3 Bolt, Length between 12mm and 22mm ("NO COUNTERSINK version")
3x M3 Nut
Assembly Instructions
- Insert the M3 nuts into the nut traps, pusing them all the way down.
- Holding just the MOUNT, screw in the M3 bolt and tighten.
- Screw the MOUNT piece onto the HOLDER, leaving a little bit of space to allow for rotation.
- Screw the CAP onto the HOLDER
- Slide the MOUNT into the TISKEN suction cup.