1 / 6
Adapter to take 3.3 volts from the expansion port (WiFi-Port) of the Prusa Buddy Board — zdjęcie 1
1 / 6

Adapter to take 3.3 volts from the expansion port (WiFi-Port) of the Prusa Buddy Board

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Do you need a 3.3 V voltage source to power any components?

Ocena
0 / 5
Polubienia
3
Pobrania
25
Wydruki
1
Wyświetlenia
622
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

Print the adapter. Remove 2 pins from a pcb header connector and solder two wires to it. One for ground (GND) and one for voltage (VCC). Insert the wires into the holes on the top of the adapter. GND and VCC are marked on the sides of the adapter. Cut the pins at the output of the adapter. You now have 3.3V at your disposal.


Although I have used this adapter myself, I disclaim any responsibility for any damage caused to the board.

Tagi