Louqe Raw S1 Top Plate Spacers For A12x15 Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Louqe Raw S1 top plate spacer - for Noctua A12x15 fan with stock top plate
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 290
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
Need: 4x M3x10 for spacers. 2x M3x5 or M3x6 for block off plate.
This is a mod to install a Noctua A12x15 fan on top of a Louqe Raw S1, while still using the stock top plate. This moves the top plate off the fan, but keeps a low profile for a stock look. I wasn't a fan of the big top hat look.
The temperature difference between the plate installed or no plate, both with an A12x15 top fan is oddly enough only about 1C on the GPU after heatsoaking. My office was also noticeably heating up during this testing so it may be even less than that.
Installation:
Remove the stock plastic piece from the case with the 4 torx screws on the side of the case. May need a bit of wiggling to come out.
Install the spacers onto the top plate. Install the plate block off into the stock plastic piece. Install the plate/spacer assembly onto the stock plastic piece. Install all of that back into the Raw S1.
The A12x15 fan can be installed directly into the stock Raw S1 top plastic piece - the slots on the side of the fan are the correct dimensions to hold it in place. This install method is needed to keep the lowest profile possible, by sinking about 7mm of fan depth below the stock plastic piece.
The plate spacers accept the stock plate screws on the top, and are held to the stock plastic piece by the M3x10 screws in the bottom of the spacer. The spacers must be threaded for the screws before they are installed - it's nearly impossible to thread them as you're trying to install them.
The plate block off piece was designed to prevent air recirculation into the fan. I haven't done any testing to see how much of a difference it actually makes. Optional.
Print in something temperature resistant - ASA, PC. The top plate gets hot during high load, PLA will warp.