1 / 5
PTFE Tube Magnetic connector - dryer/drybox base
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Glue it directly to your drybox or filament dryer, and use it to snap your PTFE tubes in place! No more dangling tubes!
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (12)Powiązane
This is a quick edit of the awesome magnetic PTFE connectors by @LineArcLine.
I wanted a base that I could superglue to my dryboxes or dryers, so I could snap a tube right to the side of the box (rather than having an ugly/unneccessary “tail” tube hanging out of the box.
I used this first on my Eibos Easdry, but it works great anywhere there's an opening for a standard 4mm PTFE tube.
To install:
- Insert magnets as usual. I used some superglue on each just to be sure they won't work their way out. Ensure that the polarity of the magnet is flipped between innies and outies.
- Cut a length of PTFE tube that will go into the dryer, push it into this base. I made the hole with zero tolerance so it will be tight! (but then it will hold it tight too)
- Put 4 small dabs of superglue onto the back of the base
- Push the PTFE tube into the side of the dryer, firmly seat the base, hold it while the glue sets
- Enjoy your clean look and lack of dangling tubes!