Rubber Foot Raiser for 3030 Aluminium extrusion eg RatRig cases
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
alternative Foot for 3030 extrusions like for the RatRig printers with higher ground clearance
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 97
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
If you are looking for a base for your 3D printer that gives you a little more ground clearance to be able to clean under the printer or to store something, then this mod is just right for you.
There are different versions:
50mm, 60mm, 70mm, 80mm and 90mm
The M8 screw in the centre is only for general rigidity and should not be tightened.
You can print the base out of TPU or any other material. TPU is used for vibration suppression so that the vibrations of the printer are not transferred to the surface. The surface should also be even. TPU can compensate for minor unevenness.