Crality K1 side fan Carbon Filter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fume filter for blower fan
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 245
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Hi, I didn't really like the smell of the fumes from some filaments so here we go I have created a activated carbon pad filter mount for the side fan. I haven't really noticed any airflow restriction of the fan, it's probably little bit influenced by that filter pad, but nothing noticeable as the fan is so strong. If you care about the clearance from print bed like I did, no worries, we have like 2,5cm of space and this cover takes 1,26cm, so there is still plenty of room.
Sponge slot size: 9x9x0.8cm !
Printing:
(Screenshots of print orientation are between the images)
Use high temp resistant material: ASA, PETG, PET, ABS etc…
Walls / Perimeters: 3-4
Layer Height: 0.2mm
Supports: Tree Supports (Organic) - takes about 1 minute to put them out, i have used PETG-CF and it went out without problems.
Activated Carbon Filter Sponge:
Can be found everywhere on the internet. I have used 15x15x0.8cm / 6pcs = 2€ on aliexpress. You need to cut the pad (scissors are enough) 9x9cm to fit the chamber in the filter.
Comment:
You can try to use the pins, but those are created for emergency situation if you dont have these basic screws which are used for PC case fans. I have found out they fit perfectly the holes in the fan. Don't overtighten the screws, they hold really well.
Enjoy :)