Ikea Fniss -> Hydroponic Tower
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design enables you to use ikea fniss trashcan as water reservoir for your hydroponic tower
- Ocena
- 4 / 5
- Polubienia
- 31
- Pobrania
- 133
- Wydruki
- 1
- Wyświetlenia
- 1765
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model enables you to use your ikea fniss trashcan as a water reservoir for your hydroponic tower.
The Ikea Fniss trashcan is quiet cheap (2.50€ in Germany) so its a good option especially for smaller towers.
I designed a normal lid and one with a hole for cable and refill. There is a plug to close the hole too.
This design uses the Module_Adapter_Custom.stl from the original design as connector to screw your tower on.
I just glued everything together. The 4 quarters can be screwed together using m3 screws.
Adjust to your needs. I provide the onshape project: Link
Guide
- 3 of “Fniss Lid quarter part” - from this printable page
- 1 of “Fniss Lid quarter Part with hole” - from this printable page
- 1 "Fniss Lid hole plug" - from this printable page
- 1 “Module_Adapter_Custom.stl” - from the other printable page
Asseble
- einter (or both) glue and screw all 4 lid plates together
- after it dried, glue the “Module_Adapter_Custom” to your lid. This makes the whole connection even stronger
- Just snap the whole thing onto your fliss trashcan
Leave a comment for feedback, a make and like :)
Have fun