1 / 2
Vz Hextrudort CW1 + Stealthburner adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter plate to mount Vz hextrudort to Stealthburner with CW1 carrige
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Requires screws longer than standard – approximately 47 mm is the maximum length that will fit without interfering with the stealthburner.
Tested only with the Vz Hextrudor Low Plus. This part is not shrinkage compensated. Print with standard Voron settings or better.
Bill of Materials (BOM):
- 2× M3 screws (45–47 mm)
- 4× heat set inserts (Ø4.7)
- 2× M3 screws (10–12 mm) for the extruder
- PTFE tube (ensure you have the correct length)
Assembly:
- Ream/drill all the M3 holes before mounting the part to the toolhead.
- Install the heat set inserts.
- Mount the extruder to the bracket.
- Install the PTFE tube.
- Assemble the toolhead.
NOTE: If you are using a toolhead board with this adapter, you might need to space the board approximately 30 mm from the carriage to ensure proper clearance.
NOTE 2: More pictures will be added later.