Banana Jack / Banana Plug (M12 Slotted Nut) Wrench for Tight Spaces, with 1/4" Socket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A thumbscrew type wrench with 1/4" socket driver hole for tightening the odd shaped nuts of through-hole banana jacks.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 36
- Wydruki
- 3
- Wyświetlenia
- 221
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
A thumbscrew type M12 slotted pin-spanner/face-spanner wrench with 1/4" socket driver hole for tightening the odd shaped nuts of through-hole banana jacks. Designed for tight/close spaces.
Print as a structural part (i.e. 0.2mm layer height, 0.4mm forced extrusion width, 40% infill, 4 walls, 5 solid top/bottom layers, and no supports). If long term use is planned, print with a tough filament. This is a use case where glass or carbon infused filaments are particularly effective, though for the expense and time cost of switching filaments, you could just print another one if the first one ever wears out.
SUPPORTING YOUR FAVORITE DESIGNERS:
If you like this, consider using one of the affiliate links below to buy your next roll of filament. Likes, follows and downloads are also appreciated.
BOM:
- Filament:
- PLA+: https://amzn.to/3CEHMk0
- PLA-CF: https://amzn.to/3DK9zQJ
- ABS: https://amzn.to/3X3hUVO
- PA12-CF (Very difficult to print, though this part should be one of the easiest to try): https://amzn.to/3RlVZpA