Source One V5 DJI O4 air unit case w/ CRSF compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Perfect fit for the Source One V5 7" dead-cat frame to become completely HD compatible.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 101
- Wydruki
- 0
- Wyświetlenia
- 530
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Perfect fit for the Source One V5 7" deadcat frame to become completely HD compatible.
Holster measured for the DJI O4 Air unit pro and is capable of holding both antennas. It also holds the TBS Crossfire Immortal T antenna with cable routing underneath holster.
I printed with BL TPU for AMS
0.16 mm layer height
15% infill
tree/organic supports (painted NO supports inside DJI antenna tubes)
** I did have to cut the forward-upward-most cross section to fit the air unit into the case, I then melted the cross section back with a soldering iron. The TPU that you use may allow for the stretching into the case.
ONE of the CRSF tubes needs to be cut in order to get the antenna to fit. Use a ziptie to close and hold the cut side together (or you could melt it like the previous step for a more permanent solution.