IBM Selectric I retrofit ribbon spool.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Takeup spool allowing 71 selectric ribbon to somewhat work on 72.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 90
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
I invariably ordered the wrong spool for my model of selectric, leaving me with a takeup spool that wouldn't even sit on the carriage. So I designed a similar empty spool that would work with the arbor of the selectric's other side. This is an extremely basic stab at a solution that is more or less working for me, if you're in the same jam you can use this model to get some life out of a useless ribbon. Just use some tape or the stick of your existing ribbon lead and give it a few turns to secure it.
Note that the outer diameter of the spool was decreased after the iteration I took photos of to limit the interference between sides of a fresh ribbon.