SG13 Front PSU Mod - Backplate with fan mounts and extension cord hole
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Comes in three categories: 80mm fan cutout; 92mm fan cutout; hex-grid cutout.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 1
- Wyświetlenia
- 282
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- GNU General Public License v2.0
Proud owner of the good old SG13 here. The pump in my water-cooling system was dying and I wanted to replace it with an air cooler that offered comparable performance. However, top-down cpu coolers, such as the NH-L12S are relatively expensive and offer worse performance than an AIO. Hence I decided to change to a tower cooler, specifically, the PA120SE. For this, I had to move my SFX-L power supply to the front. In fact, if you have a large GPU, an SFX-L PSU is optimal for this mod, as you can easily mount it on the front of the case using the 120mm screwholes and leave room for the GPU. After moving the PSU, the SG13 case was left with a gaping hole in the back that I wanted to cover. Hence I created this model.
If you want to repeat my mod, You will need a C13 to C14 angled extension cord and a few M3 nuts, bolts and spacers. You can find all of this on Aliexpress for cheap.
Regarding the files - the 92mm version has only two holes for the fan, but fits tightly alongside the roof of the case, so you don't need to worry about wobble. The 80mm version has cutouts for all four fan mounts.