1 / 1
LG Refrigerator Door Bottom Hinge Bushing 4984JJ3003A — zdjęcie 1

LG Refrigerator Door Bottom Hinge Bushing 4984JJ3003A

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement for the door bottom bushing on several LG refrigerators. LG part # 4984JJ3003A

Ocena
5 / 5
Polubienia
8
Pobrania
87
Wydruki
1
Wyświetlenia
319
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The bottom door bushing (part # 4984JJ3003A) on my refrigerator (LG LDC24370SW ASWCNA2)  wore out and one of the hinge screw heads on the door was starting to scrape on the hinge pin plate below.

Replacement is $12.95 USD + tax & shipping (A little over $21 all together.) $13.95 and shipping has gone up, now $29 total (2026-11-04), at https://lgparts.com/products/4984jj3003a when they are in stock. (Which isn't all the time. Like when I needed one.)

See complete list of compatible refrigerator models at the above link.

Recommend printing in PETG with two walls, 100% concentric infill, and random Z seam. No supports needed.

Tap it into the socket on the door and add a little silicone grease to the flange and inside of the bushing.

 

Update: PLA2 only held up for a little more than two months before the flange began to split on the Z seam. (The seams were aligned and may have been a weak point. Also, the refrigerator is pretty high traffic in my six person household and has a fully loaded door.) I've reprinted it in PETG with random seams and will see how it does. The real problem seems to be a lack of support for the bottom of the bushing's flange – it rests on a relatively small built in steel flange on the hinge pin. If PETG doesn't hold up either, I'll add a separate washer to go around the steel flange or build one into the bushing itself. Either solution would provide a lot more support.

 

Update 2: PETG with random seams at 31 months and still going strong.

 

Exact fit model: For best fit, print in “exclusive” mode (Cura) or equivalent; otherwise, you may need to adjust horizontal expansion slightly.

Tagi