Additional heating of the Prusa Core One chamber
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
additional heating with a dryer for a quick increase in temperature
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 3173
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
I noticed that when printing with ASA filament, it takes more than 20 minutes to heat the chamber to 55°C.
That's why I decided to make an adapter mounted in the top vent grille so that you can raise the temperature faster with a hair dryer (NOTE, I think it's best to do this before running the program)
Printing:
after proper positioning, it fits completely on the heating table in Core ONE
print with supports
filling 15%
In the testing phase
using the lowest power of the hair dryer is completely sufficient and will not distort the plexiglass. DO NOT USE A HEAT GUN, IT WILL MELT THE PLEXIGLASS ! ! !