1 / 1
Improved 2020 mounted case for BTT MMB CAN board
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of BTT MMB CAN board case/mount to fix numerous pain points.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Designed to mount vertically on the back of rear rail on which I have my ERCF mounted but could go on whatever 2020 extrusion you want.
I also made the following tweaks for usability:
- Larger cutout on one end to accommodate use of ferrules in the power connector.
- Small cutout to make USB-C cable fit neatly.
- Added material in upper right corner of lid to give it some rigidity where the wires enter.
- Added additional tab to the lid on the end near this area for more stability. Probably overkill.
- Moved/shrank the zip tie paths so that the zip ties don't block the cover from actually seating properly.
- Scaled it up a tiny bit so it's ASA/ABS compliant and you don't have to hammer the board to get it to snap in.
No supports needed. Just use the typical print settings prescribed by Voron or ERCF.