1 / 1
Improved 2020 mounted case for BTT MMB CAN board
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of BTT MMB CAN board case/mount to fix numerous pain points.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 28
- Makes
- 0
- Views
- 201
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Designed to mount vertically on the back of rear rail on which I have my ERCF mounted but could go on whatever 2020 extrusion you want.
I also made the following tweaks for usability:
- Larger cutout on one end to accommodate use of ferrules in the power connector.
- Small cutout to make USB-C cable fit neatly.
- Added material in upper right corner of lid to give it some rigidity where the wires enter.
- Added additional tab to the lid on the end near this area for more stability. Probably overkill.
- Moved/shrank the zip tie paths so that the zip ties don't block the cover from actually seating properly.
- Scaled it up a tiny bit so it's ASA/ABS compliant and you don't have to hammer the board to get it to snap in.
No supports needed. Just use the typical print settings prescribed by Voron or ERCF.