Clamping Keyboard Holder for Desks or Tables

This holder can clamp onto a thin table or desk and hold a wireless keyboard. This holder is specifically designed for the Logitech MX Keys S keyboard, and should accommodate keyboards of similar dimensions and weight. The holder can fit on desks or tables that are 25mm or thinner. I made it to fit onto an IKEA Bollsidan table, and it fits well when the screw is tightened. The screw is made to have a tight fit. The first time you screw it in you may be unable to screw it in fully by hand, but once you screw it in all the way it should be hand tightenable. If you have any problems you can try scaling the screw very slightly. The pieces of the holder all slot together and do not require glue or metal screws. The upper part of the “arms” slot into the main body that clamps onto the desk, and the lower part are pushed together into the bottom of the upper arms. The design is easily printable. Make sure not to generate supports around the coupling parts of the “arms”, as it may be hard to remove and interfere with the fit. 

You need to print one of each of the following: the base, the upper left arm, the lower left arm, the upper right arm, and the lower right arm. You need to print two screws. You should be able to get all pieces to fit onto a single build plate if you have a P1/X1/A1 series printer, or a printer with a similarly sized bed.