1 / 2
Mount for sidemounting a 10.9in iPad for Ratrig V-Core3 or V-Core4 — zdjęcie 1
1 / 2

Mount for sidemounting a 10.9in iPad for Ratrig V-Core3 or V-Core4

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount for sidemounting a 10.9in iPad for Ratrig V-Core3 or V-Core4

Ocena
0 / 5
Polubienia
1
Pobrania
12
Wydruki
0
Wyświetlenia
148
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

A mount for using a 10.9 inch iPad at the side of a printer, including Ratrig V-Core3 and V-Core4. The mount attaches to the vertical extrusions with a single M6, and the tilt can be adjusted. As the fixing point is near the center of gravity for the iPad, the torsional force is low and the single M6 is enough. The mount is symmetric, so you can attach it to either left or right.


The model includes a built-in support structure. As Orca slicer seems to prioritise building walls before the bridges, the bridging support must be wider than the wall thickness, otherwise the walls will be printed on top of an empty space. I printed with 3x0.4mm walls, which seems to work ok as the support is 1.6mm wide at the top.

You'll need 2x M6x10 (or longer) countersunk screws to fix the backplate to the “fixing arm”, which then in turn is attached to the printer.

Also, see https://www.printables.com/model/1712443-detachable-adapter-for-4040-or-3030-profile-for-th

 

Tagi