Ender 3 V3 Bed cable strain relief right angle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Strain relief to redirect the cable at a right-ish angle from the bed
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 409
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
The Ender 3 V3 bedslinger is a long-boii. From endstop to endstop on the Y axis it requires almost 600mm of room (including the bed cable looping away).
That would not have fit in the ikea lack table enclosure I'm currently building, so I made this alternate cable holder to re-direct the cable at a right-ish angle from the bed. I made it not quite 90deg to make sure the cable is well clear from the grantry belt when the bed is fully forward.
Two versions available:
- 4mm mounting holes for a M3 brass insert (4.7mm OD)
- 2.6mm mounting holes for self tapping.
The self tapping is sturdy enough but offsets the bottom piece a little once mounted due to the print orientation adding a bit of sag to the mounting holes. Maybe it-ll work better on your printer.
You can re-use the original countersunk bolts.
I printed the bottom piece vertically on the bed-facing edge, with support and brim. The top piece can be printed flat, no brim, with or without support for the tab. See last image.
Print in PETG 3w, whatever infill. PETG important as this piece contacts the bed and will deform immediately on the first print if printed in PLA.
Hope this helps someone.
PS: Printed in Overture Basic Petg Green. I find it matches the creality colour scheme pretty well.