X-Shot Longshot "Long boiii" Side Picatinny Rail
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
RedCowl's Side Picatinny re-done
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 109
- Wydruki
- 1
- Wyświetlenia
- 823
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I custom-built these lower-profile, larger side rails, inspired by RedCowl's Side Picatinny design.
My goal was to mount accessories on the side rails without interfering with attachments on the main rail.
You can customize your rail setup by attaching them on both sides, or just on the left or right. If you're looking for shorter rails or different angles, check out RedCowl's original post. These are the specific rails I use, and I don't plan to recreate his other rail angle designs.
For hardware, you'll need four M2.6x10 screws. I opted for Allen screws for added comfort, but the toy screws that come with the Longshot will also work.
To print these rails, place the largest flat surface directly on the print bed. Position the rails vertically, with the rounded side facing the build plate (refer to the images for a visual guide).
For print settings, I used 3 walls and 20% gyroid infill, with tree supports.
IMPORTANT NOTE!!!!!!!!!!!!
To use my rail design, you'll need to remove this specific part from the ram rod. You can either cut it down or remove the screw to detach it.

Changelog:
26/07/2025 Update - Added NATO standard rails.