Solvol3D SV01 SKR v1.3 bracket replacement Motherboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a bracket I made for a following video on my Youtube channel, for replacing the motherboard on the Solvol3D…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 295
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a bracket I made for a following video on my Youtube channel, for replacing the motherboard on the Solvol3D SV01 to a SKR V1.3 32bits controller using Marlin 2.0
V2 - Moved the board 2mm away from the side of the case
*WARNING*
My printer had 24 volts between V- and the case ground, I have burned 2 boards and 8 drivers before finding this:
The screws holding the power supply are too long and shorted out inside the power supply, I recommend that you take out 1 screw, measure the thread length, if it's 6mm add a couple of washers to bring the threads between 4mm and 4.5mm and do all 4 screws the same way. (See my pictures)
Print Settings
Printer:
Haribo
Rafts:
No
Supports:
No
Resolution:
0.1 mm - 0.3 mm
Infill:
15 %
Filament:
Amzd3D PLA
Black
Notes:
I used 0.3mm layer height.
Category: 3D Printer Parts