1 / 17
Blow your friends away with this 18650 battery powered handheld fan!
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A portable focused fan to efficiently keep cool when it gets hot.
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 1388
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (38)Powiązane
This fan runs on dual 18650 batteries. The necked down nozzle design increases air velocity for optimal cooling.
Bill of materials:
- Bottom cap contact spring: https://a.co/d/hnrPVWE
- Sliding Switch: https://a.co/d/9z3JiiK
- Spring contacts: https://a.co/d/fJww65j
- Wire (22-26 gage)
- 5015 5v fan: https://a.co/d/h01AMWS
- 4X M3X20 screws
- 3X M2X5 screws
- 2X M2X5 button head cap screws
- 2X M2X4X4mm heat set inserts
- 2X 18650 button head batteries: https://a.co/d/1O74CSD
Consumables:
- Solder
Printing:
Printing is straightforward.
Orientation:
All parts are pre-oriented for best results
- The fan cover is grill down
- The body is back down
- The battery cap is bottom down
- The Pos contact retainer is flat down
Parameters:
- Use organic supports on build plate only
- .20LH or finer
- ABS/ASA/PC recommended for heat resistance (in case you leave it in a hot car)
- 15% Gyroid
- 3 walls
Assembly:
- Feed the + wire from the fan to the switch pocket.
- Solder the fan + wire to one of the outer contacts on the switch.
- Feed a second (≈2") wire between the switch pocket and the positive contact
- Solder the second wire to the middle contact on the switch.
- Place the positive contact, cone down in the fan slot.
- Insert Pos contact retainer
- Solder the second wire from the switch to the positive contact tab, which is still exposed
- Run the fan ground" wire to the bottom of the handle and solder it to the contact spring
- Insert the contact spring in the 3mm hole in the handle.
- Install the fan
- Pull any wire slack into the switch pocket.
- Install the fan cover with (4) M3x20 screws
- Install the switch with (2) M2x5 button head screws
- Install the negative contact into the handle using (1) M2x5 screw or simply press fit, with the tab poking through the locating ring.
- Install (2) M2x4x4 heat set inserts at the bottom of the handle
- Install batteries
- Screw bottom cap in place with (2) M2x5 screws
- CHILL!