Blow your friends away with this 18650 battery powered handheld fan!
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.53 – €5.54 net (excluding VAT)
For file: Hand Fan -0.4n_0.2mm_PLA_XLIS_3h47m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.04 excluding VAT (range midpoint).
- Weight reported by the author
- 89 g
- Print time reported by the author
- 3.79 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A portable focused fan to efficiently keep cool when it gets hot.
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 63
- Makes
- 0
- Views
- 1,388
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
This fan runs on dual 18650 batteries. The necked down nozzle design increases air velocity for optimal cooling.
Bill of materials:
- Bottom cap contact spring: https://a.co/d/hnrPVWE
- Sliding Switch: https://a.co/d/9z3JiiK
- Spring contacts: https://a.co/d/fJww65j
- Wire (22-26 gage)
- 5015 5v fan: https://a.co/d/h01AMWS
- 4X M3X20 screws
- 3X M2X5 screws
- 2X M2X5 button head cap screws
- 2X M2X4X4mm heat set inserts
- 2X 18650 button head batteries: https://a.co/d/1O74CSD
Consumables:
- Solder
Printing:
Printing is straightforward.
Orientation:
All parts are pre-oriented for best results
- The fan cover is grill down
- The body is back down
- The battery cap is bottom down
- The Pos contact retainer is flat down
Parameters:
- Use organic supports on build plate only
- .20LH or finer
- ABS/ASA/PC recommended for heat resistance (in case you leave it in a hot car)
- 15% Gyroid
- 3 walls
Assembly:
- Feed the + wire from the fan to the switch pocket.
- Solder the fan + wire to one of the outer contacts on the switch.
- Feed a second (≈2") wire between the switch pocket and the positive contact
- Solder the second wire to the middle contact on the switch.
- Place the positive contact, cone down in the fan slot.
- Insert Pos contact retainer
- Solder the second wire from the switch to the positive contact tab, which is still exposed
- Run the fan ground" wire to the bottom of the handle and solder it to the contact spring
- Insert the contact spring in the 3mm hole in the handle.
- Install the fan
- Pull any wire slack into the switch pocket.
- Install the fan cover with (4) M3x20 screws
- Install the switch with (2) M2x5 button head screws
- Install the negative contact into the handle using (1) M2x5 screw or simply press fit, with the tab poking through the locating ring.
- Install (2) M2x4x4 heat set inserts at the bottom of the handle
- Install batteries
- Screw bottom cap in place with (2) M2x5 screws
- CHILL!