Tool Board Mount and/or Magnetic Parking for Jubilee Tool Changer's Baby Bullet Extruder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
'dumb' tool board mount/brace that turned into magnetic parking.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Dumb tool board for Jubilee Baby Bullet can be found on oshpark.com:
- tBoard_v_0_2 for E3D v6: https://oshpark.com/shared_projects/AKkYKPt3
- tBoard_v_0_3 for E3D v6 Groovemount, not tested: https://oshpark.com/shared_projects/q5dQgPIo
- tBoard_v_0_4 for E3D Revo Micro: https://oshpark.com/shared_projects/LIYvVRpO
There is a version of the tool board brace/mount with and without magnets.
Not tested but magnet brace should work without the tool boards depending on your setup, OpenSCAD file is provided if changes are needed.
Brace is mounted on tool by replacing bolts for part fans with longer 18 or 20mm bolts that extend though the brass inserts into the brace.
- The orbiter 2.0 version is untested and moves the tool board up 2.0mm; Without the tool board it shouldn't mater which version you use.
Frame side, parking magnet sits on top of the tool holder, with legs going in the Allen wrench holes. I included multiple parkingTHMagnet_v0_3-*.*.stl with the magnet moved farter from tool to make easier for machine to remove tool from parking spot.
- parkingTHMagnet_v0_3-0.6.stl, is closest and the only option with a hole for a Allen wrench to adjust tool height.
- parkingTHMagnet_v0_3-7.6 is adjusted as far away as possible.
- parkingTHMagnet_v0_3-6.0, is the one I am using.
½" x 1/8" Magnets are embedded in the parts while printing, add a pause as needed in slicer, make sure to keep the same magnetic pole pointing down on all parts.
Warning: parking, pickup scripts and print area need to be checked and updated if needed to avoid collisions; I have my print area set to 290 in Y, your results might vary.