Vibe Sea Ghost 110 Fish Finder Transom Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Attach your transducer to your Vibe Kayak without paying the absurd price of an official one.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 711
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I got a new Vibe Sea Ghost 110 kayak and a Humminbird Helix 5 fish finder, and in going through the process of modifying, customizing, and setting up my kayak, I got very upset with finding out I would have to repeatedly spend upwards of $20-$50 for the next piece of plastic I would need.
In this case it was to attach my Humminbird Helix 5 fish finder transom mounted transducer. So I came up with a bracket design that would work and printed it for around $2 in material. This would likely work for other finders on the Vibe Sea Ghosts as well.
Even though the bracket has the screw holes to match a perfect layout on the Vibe kayaks, my kayak itself was actually a little off of perfect. One of the pre-drilled holes in the hull is a little off kilter, so I had to widen one of the the bracket holes a bit post-print. However since that is the kayak's fault and not the bracket, I am leaving the design as accurate. Use M5 stainless steel bolts to put it in place.
Print Settings
Printer Brand:
Dremel Digilab
Printer:
3D20
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
100%
Filament: PLA PLA Green
Category: Sport & Outdoors