Vibe Sea Ghost 110 Fish Finder Transom Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Attach your transducer to your Vibe Kayak without paying the absurd price of an official one.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 46
- Makes
- 0
- Views
- 711
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I got a new Vibe Sea Ghost 110 kayak and a Humminbird Helix 5 fish finder, and in going through the process of modifying, customizing, and setting up my kayak, I got very upset with finding out I would have to repeatedly spend upwards of $20-$50 for the next piece of plastic I would need.
In this case it was to attach my Humminbird Helix 5 fish finder transom mounted transducer. So I came up with a bracket design that would work and printed it for around $2 in material. This would likely work for other finders on the Vibe Sea Ghosts as well.
Even though the bracket has the screw holes to match a perfect layout on the Vibe kayaks, my kayak itself was actually a little off of perfect. One of the pre-drilled holes in the hull is a little off kilter, so I had to widen one of the the bracket holes a bit post-print. However since that is the kayak's fault and not the bracket, I am leaving the design as accurate. Use M5 stainless steel bolts to put it in place.
Print Settings
Printer Brand:
Dremel Digilab
Printer:
3D20
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
100%
Filament: PLA PLA Green
Category: Sport & Outdoors