1 / 3
Spraycan Nozzle Holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my first ever design! I would get frustrated trying to use the flimsy piece of tape used to secure the nozzle for spraycans over and over; it gets dirty and loses its adhesiveness and eventually the nozzle can come loose and get lost in the workshop.
My design is very simple and secures the nozzle in a slot and then attaches to the can using a 8x3mm neodymium magnet. Simply use a drop of superglue to hold the magnet in the hole.
I tested this using two different cans, WD40 and an air duster, both were approximately 52mm in diameter