Creality Falcon2 Pro - Quiet the beep
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Creality Falcon2 Pro - Quiet the beep
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 237
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
In order to quiet down the beep of your Creality Faclon2, you need to put a few layers of tape over the beeping module on the control board(red highlighted module) with blue tape already in place which is located in the front right corner of this unit.
In order to do this, you need to first remove this cover.
Use a 2mm allen wrench to remove the (4) 2mm screws holding the board cover in place.
Once this plastic cover is removed, you need at least two layers of tape to put over the beeping module. I used four layers o blue electric tape. This cut the volume down significantly.
I was going to remove the tape so I could take the before picture but the module came with it. No longer have a beep at all! I do like the beep for checking movement into the limit switches but not a big deal.
