1 / 4
Makita 18v adapter - remix for 3mm bolts — zdjęcie 1
1 / 4

Makita 18v adapter - remix for 3mm bolts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

18v Makita Battery adapter remix with 3mm mounting holes.

Ocena
5 / 5
Polubienia
37
Pobrania
343
Wydruki
2
Wyświetlenia
2534
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of fablab.ee's Makita 18V battery adapter with mounting holes for m3 bolts in a slightly different location to better suit my requirements with a 52x58 mm pattern. 

The holes are also countersunk further so the same length bolts can be used in all 4 holes.

I have also modified the retainer plate to indicate contact polarity and allow access to the status pin if you wish to include circuitry to monitor LXT battery state.  I do not do this, but there is an over-discharge prevention circuit on Instructables : https://www.instructables.com/Making-a-Over-Discharge-Protection-for-Makita-Batt

As with the original design, this adapter fits Makita 643852-2 Battery terminals.  These are available from many sources, including Amazon and eBay.
 

There are overhangs, but I was able to print without supports.  There are a few hanging filament strands, but not enough to impact functionality.

Tagi