1 / 1
Voron 2.4 (or any other) 2x120mm controller fans in bottom panel — zdjęcie 1

Voron 2.4 (or any other) 2x120mm controller fans in bottom panel

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A mount for 2x120mm bottom fans

Ocena
0 / 5
Polubienia
10
Pobrania
20
Wydruki
0
Wyświetlenia
185
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Title says it all! Be careful with vertical clearance on the inside. I used double sided tape to mount the fans at first to the panel to check I can close it with the fans in the desired position.
 

Put painters tape on the panel and then use the mount to sketch the outlines onto the painters tape. Use a jig saw to cut out the holes (with some extra room around it, be careful to not get to close to the holes.

I melted heatset inserts into the fan and used M3x8, you can also use longer M3 screws and nuts. The screw head holes are sized for M3 SHCS.

I install this mod here: 

Tagi