OXO GoodGrips / SoftWorks Corn Holders Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple storage for sharp corn holders. Likely works with plenty of other models, but this one is for the OXO ones.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 65
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple storage solution for sharp corn holders. Holds up to a set of 8.
Likely works with plenty of other models-- check the spacing between the tines-- but this one was designed specifically for the OXO SoftWorks Corn Holders.
Model shown printed in PLA+ at 0.28mm height, “top” side (where the holders get inserted) printed on build plate for smooth surface. 10-15% infill is fine; no need to waste a lot of filament on something you'll print, throw in a drawer and never think about again.