1 / 3
OXO GoodGrips / SoftWorks Corn Holders Holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple storage for sharp corn holders. Likely works with plenty of other models, but this one is for the OXO ones.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 10
- Makes
- 0
- Views
- 64
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple storage solution for sharp corn holders. Holds up to a set of 8.
Likely works with plenty of other models-- check the spacing between the tines-- but this one was designed specifically for the OXO SoftWorks Corn Holders.
Model shown printed in PLA+ at 0.28mm height, “top” side (where the holders get inserted) printed on build plate for smooth surface. 10-15% infill is fine; no need to waste a lot of filament on something you'll print, throw in a drawer and never think about again.