CWWK X86-P5 NAS board case - 4xNVME + 2xSSD
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for CWWK x86-P5 which has space for 2 SSDs
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 441
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The fan is a regular 120mm PC fan. The shield is for the board with red USB ports and FPC cable (rev 1.1). I might upload the shield for the board with blue ports as well. No promises.
The shield is separate from the main body. It can be attached with super glue. Glue it after closing the top lid to make sure the case is in shape.
I would recommend to print the “bracket” which screws to the heatsink with PETG or ABS/ASA. I have a feeling PLA would be fine too because it is in front of the fan. Even if the bracket warps, the heatsink should be able to rest on top of the fan.
I printed everything with ABS filament which was a bit wet hence the bad quality. I didn't bother re-printing.
First screw the bracket to the heatsink, then screw the bracket on top of the fan (the fan will blow air to the heatsink), then put the whole thing inside the case and screw the fan to the case. I will put some photos showing the way things fit together.
***
Hardware needed:
Super glue for the shield
2x M3x6 screws for each SSD
4x M3x6 screws with insets for the lid
4x Fan screws (I think those are M5)
4x M2x6 screws to secure the heatsink to the bracket
***
Shield is taken from https://www.printables.com/model/934325-cwwk-x86-p5-devboard-case
And fan grill is taken from https://www.printables.com/model/1096961-high-efficiency-noctua-120mm-fan-grill