1 / 3
Toyota Prius Gen 2 Key Fob Button Repair
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model replaces the rubber button cover on the Toyota Prius Gen 2 (2004-2009) key fob. Print in TPU. STEP included.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 50
- Wydruki
- 1
- Wyświetlenia
- 260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (10)Powiązane
Description:
This design for the Toyota Prius Gen 2 key fob cover includes the panic button on the front of the fob that most 3-button versions include. Tolerances and geometry of the original model have been completely redesigned for better fitment. This replacement cover is compatible with the Gen 2 Prius key fob, Toyota part #89994-47061.
Print Settings:
- TPU/FLEX filament required! PLA and PETG will NOT work.
- Layer Height: 0.15-0.2mm
- 3x Perimeters recommended for durability.
- 100% infill.
- Print model as oriented in the STL, with the button symbols face-down.
- No supports.
Assembly Instructions:
- Remove and clean any remaining rubber from the key fob buttons/housing.
- Be careful not to damage internal electronics!
- Prepare for gluing: use isopropyl alcohol to clean any dust and grim from the plastic button housing.
- Test fit before gluing! Verify fitment is tight/printer calibration is accurate.
- Apply a moderate amount of cyanoacrylate (CA/superglue) around the perimeter of the key fob button housing.
- Install the TPU replacement cover correctly oriented and hold down/tape down the edges to ensure a tight fit as the glue sets.
- Optional: paint in the button symbols for higher contrast (see below), or get fancy with multicolored printing.


