Zenner Water Meter Cover – Simple Replacement Lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple replacement lid for Zenner water meters. Easy to print, fits well, and designed from scratch in FreeCAD.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 174
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
If your Zenner water meter's original cover broke at the hinge—like mine did—this model might be just what you need. This is a basic, no-frills replacement lid for a Zenner-brand water meter found locally through my area’s utility provider. The original lid broke at the hinge point, so I took measurements using a set of calipers and designed a completely new one from scratch in FreeCAD.
The result is a simple, reliable, and very easy-to-print design that fits perfectly in place of the original. There are no fancy features, just a clean, functional part that does the job.
I printed mine using Creality Hyper PLA, and it’s been holding up nicely. That said, your results may vary depending on climate and exposure. Feel free to remix or adapt it to suit your specific water meter setup—especially if yours differs slightly in shape or hinge type.
This model is published in case someone else finds it useful. I’m not expecting huge demand, but hey—if it helps someone skip the trial and error phase, then it's done its job.
Notes:
- Modeled in FreeCAD
- Based on physical measurements taken with calipers
- Optimized for easy printing with minimal or no supports
- Should fit standard Zenner water meters found in some local utility installations
- Share remixes if you adapt it for different models!