SpinKnuckle Leverless Controller Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Updated model of my leverless hitbox design. Uses arcade style push buttons and meant to be lightweight and tool-less
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 288
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A newer attempt at my leverless acade stick. Uses actual slim base push buttons 24mm and 30mm (purchased separately; I recommend something like the ST-L2 from Aliexpress). Wiring can be a mess, I recommend NOT using a standard wiring harness and custom wiring your setup and cutting to actual length to make it fit perfectly. Fits most PCBs but I designed it for a Picopi so other things might not fit. I designed it to be screw-less friction fit, so there are notches at the corner for the semi-tool-less access using a coin or a strong finger nail to pop open the enclosure. The entire enclosure is also sloped for comfort. If using on table top, recommended adding anti slip grip tape/mat to bottom.
You'll need at least the following:
- 17x - 24mm (low depth push buttons, 11mm or shallower)
- 01x - 30mm (low depth push button, 11mm or shallower)
- 01x - PicoPi or equivalent fightstick pcb (not tested for larger pcbs could possibly work or modded to fit)
- optional grommet for cable outlet (will design cover hole at later point)
I'll try to keep this post updated as frequent as I can and update with design changes from users. Next update will be Mixbox design with WASD and additional buton layouts.