1 / 2
X Shot Motorized Piston Pump 'Terrier-K/M/XL' short and long handguards — zdjęcie 1
1 / 2

X Shot Motorized Piston Pump 'Terrier-K/M/XL' short and long handguards

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Short an long versions of the Terrier handguard for the MPP

Ocena
5 / 5
Polubienia
82
Pobrania
459
Wydruki
6
Wyświetlenia
2202
Oceny
6

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Outdoor Toys
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

IMPORTANT UPDATE:
DON'T PRINT version 1.01 of the XL handguard. There was an issue resulting in a 3mm gap towards the rear. Please print the new 1.02 version instead. This issue doesn't affect the M and K versions.

Handguards for the Motorized Piston Pump by XShot. Inspired by the HK433.
There is picatinny on the 12 o'clock position and usable M-LOK on the sides and bottom.
Slide over the barrel collet from the front. 2 bolts clamp it down. 
.stls come pre-oriented. .stp files are included. Prints without support.

Original: 210mm long
K (Kurz) - Shortest version; 130mm long
M (Medium) - Sligthly shorter than original; 170mm long
XL (Xtra Long) - Longer than original; 250mm long (231mm print height required!)

REQUIRED HARDWARE :
- 2x M5x30mm socket head screw
- 2x M5 Hex nuts (Nylon lock nuts recommended) 
 

Tagi