GONG Foil Shim VELOCE Tail Wing V3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fully adjustable rear wing system with a carbon shaft and an interchangeable angle shim, which you can now 3D print ..
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 361
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
In the new GONG back wing / stabilizer system, you can adjust the back wing/stabilizer’s angle of attack using a shim.
Here we have two shims: one for 0 degrees – which is needed if you want to ride without any adjusted angle of attack – and one for −0.5 degrees.
A shim should always be installed; never screw carbon directly onto carbon.
I think the GONG website doesn’t explain this very clearly. GONG’s idea seems to be that the 0-degree shim is supplemented by an additional shim, not replaced.
Here, however, it’s different:
The two shims shown here each work on their own – so you use either the 0-degree shim or the −0.5-degree shim.
Bei dem neuen GONG-Backwing- bzw. Stab-System kann man den Anstellwinkel des Backwings/Stabs mithilfe eines Shims verändern.
Hier liegen zwei Shims: einer für 0 Grad – den man benötigt, wenn man ohne korrigierten Anstellwinkel fahren möchte – und einer für −0,5 Grad.
Es sollte immer ein Shim montiert sein; also niemals Carbon direkt auf Carbon schrauben.
Ich finde, auf der GONG-Seite wird das nicht sehr deutlich erklärt. Die GONG-Idee ist wohl, dass der 0-Grad-Shim durch einen zusätzlichen Shim ergänzt (nicht ergänzt) wird.
Das ist hier anders:
Die beiden Shims, die hier vorliegen, reichen jeweils für sich aus – man verwendet also entweder den 0-Grad-Shim oder den −0,5-Grad-Shim.